Acron Paints

Epoxy Zinc Phosphate

Product Function

An epoxy resin based air dry primer. This product adheres well and provides protection to correctly prepared steel surfaces (before over-coating takes place). Epoxy Zinc Phosphate is suitable for application by spray, brush or roller (depending upon area size) This is a hard-wearing primer which is economical as the paint is still useable once the pot has been opened. Most commonly used as an intermediate coat.

Surface Preparation And Application

Surfaces to be coated must be dry and clean ensuring that no grease remains. Degreasing may be carried out using Universal Thinners, maximum efficiency will be achieved using vapour degreasing. The product can be applied using conventional or airless spray equipment and can be adjusted for use with electrostatic spray equipment. Conventional spraying requires the paint to be thinned to a viscosity of 30 to 50 seconds at ambient temperature, or 10% by volume.

Priming

Mild Steel: Two Pack Self Etching Primer, AP1 Red Oxide Primer or Zinc Rich Primer
Aluminium: Two Pack Self Etching Primer
Stainless Steel and Zintec: Single Pack Etch Primer

Properties

Packaging	1, 2.5, 5 and 25 litres.
Flash Point	May Occur between 22 and 32°C
Shelf Life	12 months if stored in original container
Storage	Store in a cool dry place under temperatures of 10 to 15°C (in accordance with the highly Flammable Liquids and Liquified Petroleum Gasses Regulations 1972).
Coverage	On a dry film thickness of 45 microns, conventional spraying will cover 5 to 8m² per litre. A thickness of 55 microns will cover 4.6m² per litre. Coverage will vary according to individual conditions.
Drying Times	These times are assuming that application takes place with an ambient temperature. Surface Touch Dry : 30 to 45 minutes Hard Dry : 12 Hours Full Cure : 7 Days
Volume Solids	Typical values of 58 - 65% dependent upon viscosity.
Cleaning	Manufacturer recommends Universal Thinners.

Product Reference No. EPZP. Issue Date August 2002

Hard Wearing and Economical

Acron Paints

Unit 6, William Street, Northam, Southampton, Hampshire, SO14 5QH

Tel: 023 80223266

sales@acronpaints.co.uk

Fax: 08700 527 587

The claims made in this document are made in good faith and are based on exhaustive tests carried out over a long period.
Acron Paints, their agents and their distributors cannot accept any liability for the behaviour of their materials in individual cases.

A printer friendly copy is available here

A Health and Safety Reference Datasheet is available here