Acron Paints Acron Paints, Unit 6 William Street, Northam, Southampton, Hants. S014 5QH Tel: 023 80 223266 Fax: 08700 527587

1. Identification of Substance

   High Copper Antifouling.

2. Composition/Information on Ingredients

   Cuprous oxide, organic and inorganic resins, non-hazardous pigments and extenders. Aromatic hydrocarbon solvent containg Trimethyl benzene.

3. Hazards Identification

   Under the chemicals (Hazard information and packaging) Regulations 1993, antifouling paints must be properly packaged and equally important, correctly labelled before it is sold to the general public. Even if someone is buying a branded antifouling in bulk and selling it in small lots, each container must be properly labelled in accordance with the CHIP Regulations, failure to comply with these regulations is not only an offence but a potential danger is posed to persons that may come into contact with the paint either during use of by accident. Over-exposure causes irritation to eyes and respiratory system. Excessive concentrations may cause headaches, dizziness, drowsiness and in extreme cases loss of consciousness. General health will be affected if the OEL is exceeded over a long period.

4. First Aid Measures

   General

   In all cases of doubt or when symptoms persist, seek medical attention. Never give anything by mouth to an unconscious person.

   Eye Contact

   Irrigate copiously with clean, fresh water holding the eyelids apart for a minimum of 10 minutes.

   Skin Contact

   Remove contaminated clothing, wash skin with soap and water. Do not use solvents.

   Inhalation

   Move casualty to fresh air, keep warm and give nothing by mouth.

   Ingestion

   Do not induce vomiting. Keep calm and seek medical attention.

5. Fire Fighting Measures

   This product is flammable and can cause flammable concentrations of vapour. Fire will produce a thick, black smoke containing harmful elements. This product can form explosive concentrations of vapour in confined spaces. Fight large fires with alcohol resistant foam and small fires with dry powder or carbon dioxide. Cool containers exposed to heat with water spray. Use SCBA in confined areas.

6. Accidental Release Measures

   Personal Precautions

   Avoid contact with skin and eyes.

   Environmental Precautions

   Do not release into the environment.

   Methods for Cleaning

   Absorb spillage in non-combustible absorbent materials such as sand or earth. Do not allow to enter drains or water courses. Exclude sources of ignition. Ventilate the area. Observe health precautions and waste disposal requirements.

7. Handling and Storage

   Handling

   Do not ingest. Avoid contact with skin and eyes.

   Storage

   Store in a well ventilated area where the temperature can remain between 1 - 25°C.

8. Exposure Controls and Personal Protection

   Exposure Controls

   wash hands with soap and water. Remove and wash contaminated clothing. Do not take internally. Avoid contact with eyes. Avoid prolonged or repeated contact with skin.

   Personal Protection

   Observe good industrial hygiene and safety practices.

   Respiratory Equipment

   Vapours and spray mists must not be inhaled. If the OEL cannot be maintained with exhaust ventilation, a suitable personal respirator should be used.

   Eye Protection

   Splashes entering the eye will cause discomfort and possible damage – wear goggles.

   Hand Protection

   Gloves should be worn.

   Skin Protection

   Wear suitable protective clothing.

9. Physical and Chemical Properties

   Appearance	Coloured liquid.
   Flash Point	34°C
   L.E.L.	0.9%
   O.E.L	0.9%
   Spray Mists	2.0mg/m³
   Vapour	125 mg/m³

10. Stability and Reactivity

    Stable under the recommended storage and handling conditions (see section 7). In a fire, hazardous decomposition products such as smoke, carbon monoxide, carbon dioxide and oxides of nitrogen may be produced. Keep away from oxidising agents and strong alkaline and acid materials to prevent the possibility of an exothermic reaction.

11. Toxilogical Information

    There is no data available on the product itself. Exposure to organic solvent vapours may result in adverse health effects such as irritation of the mucous membrance and respiratory system and adverse effects on the renal and central nervous systems. Symptoms include headache, dizziness, fatigue, muscular weakness, drowsiness and in extreme cases unconsciousness. Splashes in the eyes may cause irritation and reversible local damage. Repeated or prolonged contact with the product, may lead to removal of natural fats from the skin resulting in non-allergenic contact dermatitis and absorption through the skin.

12. Ecological Information

    Is approved by the HSE under the "Food and Environmental Protection Act 1985 : Part III" and "The Control of Pesticides Regulations 1986".

13. Disposal Considerations

    Waste such as contaminated solvent and cleaning rags should be sealed in metal containers and disposed of correctly. Consult your local authority.

14. Transport Information

    Not classified as dangerous for supply/use.

15. Regulatory Information

    Classification

    Not classified as dangerous for supply/use.

16. Other Information

    The information contained in this safety data sheet is provided in accordance with the requirements of the Chemicals (Hazard Information and Packaging) Regulations. The product should not be used for purposes other than those shown in Section 1 without first referring to the supplier and obtaining written instructions. As the specific conditions of use of the product are outside of the suppliers control, the user is responsible for ensuring that the requirements of relevant legislation are complied with. The information contained in this safety data sheet is based on the present state of knowledge and current national legislation. It provides guidance on health, safety and environmental aspects of the product and should not be construed as any guarantee of technical performance or suitability for particular applications.

Acron Health and Safety

A printer friendly copy is available here

A Technical Reference Datasheet is available here