Chassis Enamel

Acron Paints

Acron Paints, Unit 6 William Street, Northam, Southampton, Hants. S014 5QH
Tel: 023 80 223266 Fax: 08700 527587

Material Safety Data Sheet

Revision No.3/2002

Suppliers Name and Address:
Acron Paints
Unit 6, William Street, Northam
Southampton, Hants. S014 5QH
Tel: 023 80 223266 Fax: 08700 527587

Product Name/s:
Chassis Enamel

Product Function

Chassis Enamel is a high quality 2 hour alkyd synthetic enamel. Coatings offer fast surface drying even in thick films, minimum yellowing and outstanding film hardness and toughness. Chassis Enamel can be used for heavy duty vehicle finishing as well as for vehicle repair work and due to its good resistance to oils, fats and cutting oils etc, makes this an ideal choice for machinery enamel. It is flexible and gives good performance over both interior and exterior wood.

Preparation/Pre Treatment

Surfaces must be thoroughly clean, dry, free from millscale, rust, oil, grease or other contaminants - use Degreasing Thinners. For non-ferrous metals, Acron Two Etch Primer must be used. Various undercoats and anti-corrosive primers are available.

Aplication

Can be brushed or hot sprayed without the addition of thinners. For conventional air assisted spray - use 20 to 25% Speed Thinners.

Properties

Packaging 2.5, 5 and 25 litres.

Viscosity as supplied Approx 3.0 poise ICE Cone and Plate Viscometer at 25°C

Flashpoint Above 32°C

Storage Stable in sealed original containers

Solids 55% approx

Colour Range All BS and RAL Colours available

Drying Times Touch Dry : 2 hours.
Hard Dry : Overnight

Overcoating 2 coats wet on wet are possible alternatively leave overnight.

Coverage At a DFT of 45 microns you should achieve 10m² per litre.

This product should be stored and handled in accordance with good industrial hygiene practice and in conformity with any legal regulation. This information is to our best of knowledge correct and given in good faith but without warranty. It remains the users responsibility to ensure the information is appropriate for any particular use of the product.

Product code CHS

August 2002

Fast driying and outstanding toughness

A printer friendly copy is available here

A Technical Reference Datasheet is available here

Packaging	2.5, 5 and 25 litres.
Viscosity as supplied	Approx 3.0 poise ICE Cone and Plate Viscometer at 25°C
Flashpoint	Above 32°C
Storage	Stable in sealed original containers
Solids	55% approx
Colour Range	All BS and RAL Colours available
Drying Times	Touch Dry : 2 hours. Hard Dry : Overnight
Overcoating	2 coats wet on wet are possible alternatively leave overnight.
Coverage	At a DFT of 45 microns you should achieve 10m² per litre.